In order to use your Propane Smoker, it is necessary to Assemble it properly. Assembling a Propane Smoker is a simple task and takes up very much less labor. Although, it is necessary to assemble it properly in order to use it effectively and to avoid any kind of accidents. In the present article on, How to Assemble a Propane Smoker we will describe to you the proper method of Assembling a Propane Smoker.
How to Assemble a Propane Smoker – Easy Steps Explained
Before starting with the Assembly of your equipment, first of all, check that whether all the necessary components are there in the setup or not. In case if any part is missing, contact the manufacturer and get it from them.
Assembly of Smoker Base
Attach the legs to both the top as well as bottom frames. Bolts are provided in the setup and you have to tighten it with hand. Use all the 16 provided bolts and tighten them with the wrench. Make it sure that the unit stands firm.
Remove the nut from the top of the Casting Bolt. Attach the bottom nut and tighten it. Insert the casting after flipping the cooker. Keep the Casting Bolt on the Flat Bar. Keep the Heat Plate on the Casting Bolt. Make it sure that the Heat Plate rests on the Flat Bar properly.
Reinstall the nut on casting bolt and tighten it. Make it sure that the Casting is standing firm.
Installation of Hose
First of all, Tighten the Hose with the Venturi using a Wrench. Don’t apply much pressure while tightening. First of all, tighten it with hand and then use the Torque Wrench for the last 1-2 turns.
Assembling a Propane Smoker Cabinet
Using the black bolts, install the stack on the top of the smoker. The stack should face the back of the Propane Smoker. Also, install the grip handles on both the sides of the Propane Smoker.
Install the dampers on both the sides of the Cabinet. Also, install the Front Door handle using the Grip Door Handle, Latch as well as Nut. In order to latch the front door, close the door and turn down the handle.
Install the Side Smoker using the Grip Handle. Keep the latch on the threaded end on the back side of smoker door. Tighten it with the nut.
Turn down the handle to keep the latch in place. Place the thermometer on the smoker door. Attach the nut on the thermometer and tighten it.
Place this Cabinet on the Propane Smoker. The Smoker Cabinet must face the Smoker Door in the opposite direction of the Hose.
Assembling a Propane Smoker – Important Points to keep in mind
It is necessary to keep all the points in mind before starting the assembly of the Propane Gas Smoker. Not following these instructions might result in Explosion, Fire Hazard, Burns, Leakage of Carbon Monoxide from the system and much more. These hazards might also result in death, injury as well as damage to property. So it becomes necessary to follow the instructions:
- Read the Manufacturer’s instruction carefully before Assembling a Propane Smoker.
- While Assembling, use only standard parts.
- Take care of the small components which might get lost. Even your toddlers can swallow it by mistake so you have to be careful while assembling.
- Assemble it only in the outdoors. It is not for indoor application.
We hope that our compilation on Assembling a Propane Smoker will be helpful to you for properly assembling and using your Propane Gas Smoker.
Do follow us on our page Smokerify for more such useful information.